Rain Bird ANEMOMETER Wind Speed Sensor

Rain Bird ANEMOMETER Wind Speed Sensor

Brand: Rain Bird | SKU: ANEMOMETER

Product Overview

Add wind-speed sensing to a compatible Rain Bird irrigation control system with the ANEMOMETER. Its three-cup sensor measures wind from 4 to 80 MPH and connects through the interface required by the controller or central-control platform. Select the sensor and interface together; the anemometer alone does not operate an irrigation valve.

Key Features

• Three-cup wind-speed sensing design.
• Manufacturer-listed wind-speed range of 4–80 MPH.
• Supplied with mounting bracket and 20 feet of cable.
• Supports the specified Rain Bird systems through the appropriate interface.

Common Uses

• Adding wind measurement to a compatible Maxicom2 installation.
• Providing wind input for a supported SiteControl, IQ, ESP-LXME or ESP-LXD setup with PT3002.

Technical Specifications

• Model: ANEMOMETER; factory part: M80302.
• Wind-speed range: 4–80 MPH.
• Sensor power supply: 5–24 VDC.
• Sensor current draw: 3–7 mA.
• Technical-sheet output calibration: K = 1.6965; offset = +0.059.
• Included: mounting bracket and 20 feet of cable.
• Manufacturer-listed weight: 1.3 lb.
• Maxicom2 interface: PT322 or PT3002 required.
• SiteControl, IQ, ESP-LXME and ESP-LXD interface: PT3002 required.
• Interface equipment and irrigation controller are selected separately.

Dimensions

• Manufacturer-listed length: 22 inches.
• Manufacturer-listed width: 8 inches.
• Manufacturer-listed height: 8 inches.

Compatibility & Installation Notes

Confirm the exact Rain Bird control platform and interface before ordering. Maxicom2 requires PT322 or PT3002; Rain Bird specifies PT3002 for SiteControl, IQ, ESP-LXME and ESP-LXD.

Plan the mounting location and cable route for meaningful wind measurement and access for service. The supplied cable is 20 feet long; any installation beyond that requires a properly designed wiring arrangement.

Follow the interface wiring and programming instructions. The sensor uses 5–24 VDC; do not treat that specification as permission to connect it directly to an AC valve output.

For PT3002 installations, use the anemometer-specific setup and calibration procedure in the PT3002 guide. Check the programmed units and controller response after installation.

Frequently Asked Questions

Can I connect it directly to any Rain Bird controller?

No. Match the supported system and required interface. Rain Bird lists PT322 or PT3002 for Maxicom2 and PT3002 for SiteControl, IQ, ESP-LXME and ESP-LXD.

What wind speeds does it measure?

The manufacturer lists a 4–80 MPH wind-speed range.

Does it measure rainfall too?

No. This model is the wind-speed sensor. Rainfall sensing uses a separate device.

What mounting items come with the sensor?

Rain Bird lists a mounting bracket and 20 feet of cable with the anemometer.

Why Buy from Big Frog Supply?

Choose this ANEMOMETER when the installation needs wind-speed input over the specified 4–80 MPH range and uses a supported Rain Bird control platform. The included bracket and 20-foot cable help define the mounting plan, while the required PT322 or PT3002 interface determines the electrical and programming path. Confirm that interface at the same time as the sensor so the installation has the equipment needed to use its readings.